Why does my HO engine not work?

[CHUG]

Steamgene, suit youself if you dont like the answer. Saddle on up and beat it to samarra.

[SteamGene]

Sid,
I'm into my second red pen.
Gene

[WoundedBear]

Sid,
I'm into my second red pen.
Gene

And chewing away wildly I bet....lmfao.....I hear the Sharpies taste better than the dollar store ones.

Did ya get to samarra yet? 

Sid

[railbuffintx78559]

NS1202

Try the following three fixes:

1.) Reset the EZ Command System, place the locomotie on the tracks, and choose an address.  If the locomotive responds, you have solved the problem.

2.) Take your locomotive apart, and examine the moving parts for wear, dirt, hair, or any other foreign substance.

3.) Finally, check all possible areas for loose contacts, connections, or even dirty wheels. 

If you have done all of these things mentioned, then ignore my message.  I would recommend sending the locomotive back to Bachmann, or sending it to a DCC specialist store, like Tony's Train Exchange, for them to repair and/or diagnose your problem.

I hope this hleps.

~Dennis~

[NS1202]

I already found out what happened, if just need to be re-set//

[Beatle (TrainBrain)]

"Re-set"... such a nice word in modeling

>click<

Dang, out of ammo.

[westsidelumber12]

How did u turn off the power? i got a ez command i messed up a decoder in my GP50 when i unplugged it. Make sure the throttle is a zero.........
And the norm is 3 but some companies mess up *Athearn*