Going from EZ command to the Dynamis

[jdamerst]

I am in On30 and had 4 of my 5 engines programed for the EZ Command. Then I decided to buy the Dynamis system .My new center cab ran beautifully under EZ command. When I went to program it under the Dynamis, I got sound, lights - but no movement even if the engine was in CV 3.

Can the Dynamis know what CV a locomotive was programmed in and accept it so it runs?

Is there a way to locate what  number engines are programmed in?

Cheers,
jdamerst

[NarrowMinded]

The basic dynamis system does not read CV's I would suggest doing a reset of the loco which will set it back to address #3

NM-Jeff

[jdamerst]

OK,
I will reset the locomotives so they are back to #3. But how do I do it?

Cheers,
Jeff

[NarrowMinded]

remove all your locos from your track place the loco you want to reset on the track select service track programing set cv8 to 8

this will do a full reset on the decoder

again only place the loco you want to reset on the track any locos on the track would be reset when using service track programming.

NM-Jeff