12.5" terminal rerailer

[mrmtox]

I am building a figure 8 with 12.5" radius track Do you sell a terminal rerailer with wire for that curvature? It will be most inconvenient if I have to use the 10" straight that I say on your site.  Thanks.

[James in FL]

I am only aware of the 11.25r curved and the 10in. straight terminal tracks.
If Bachmann has recently produced others, I have yet to see them. Those are the only two currently on the products page.
The 10in could always be cut down to fit, if necessary, or you could use a competitor product with wires soldered to joiners.

I don't feel its proper etiquette to publically mention the manufacturer on the Bachmann board but if you pm, I will sent you the link and part number.

Are you building your figure 8 over and under or vertical using a  X crossing?

[mrmtox]

James - thanks for this info also.  I am also only aware of the 11.25R and 10 " straight availability. I can rearrange the design a bit to make the 10" straight work fine. Haven't decided yet on a flat crossing or elevated cross over. I'll have an oval that has one end elevated over part of the figure 8. Thanks again!

[the Bach-man]

Dear MRM,
I believe Atlas makes the terminal joiners of which James speaks.
Have fun!
the Bach-man