Using 2 Bachmann DCC EZ Comand Controllers

[RustyNail]

Hello.  I am building a duel level 24' x 14' layout.

Currently the system is using Bachmann DCC EZ Command Controller with a Bachmann Walkaround Controller.

My question is:  Without adding the Bachmann Power Booster,  can I add a second DCC Controller to the upper level with the same address for all the same engines.  I will isolate the upper and lower section, so there are no power issues.  Trains, not in operational status, will be isolated to track with power removed.

I feel the one controller will not power both sections with several trains in operation.

Thanks.  Rusty Nail

[rich1998]

Welcome.

To my knowledge, one controller at a time.
Shop around for better booster prices if you need a booster or get a better DCC controller.
I would suggest a better DCC controller to change CV's which the EZ Command will not do.
Last I knew, you cannot reset a wonky decoder with the EZ Command. A decoder does get wonky at times.

Rich

[Len]

If you plan to isolate the levels using typical gaps, you will run into problems when loco wheels bridge the gaps if you are using two controllers. Better to just get a booster if you feel your basic system doesn't have enough power.

Len