Thanks Jim you heip me a lot.
Thanks again
Bob

Will atlas switches work on DC or only on AC?

I have a friend who wont's to give me the set atlas master commander generator and the handcommand i needed to know if i should take it.he said that it was made by Lenz

Dose any one know any thing about the atlas master commander it's made by lenz is it a good dcc unit?

I have a digitrax SDN144PS decoder I'm putting it in a diesel dose any one know where the F1-green wire and the F2-violet wire go (i think they are the function leads )but where do they go or do they get cut off
Thank's for your help
Robert

THANKS FOR ALLYOUR INPUT.
Robert
PS can you use any other throttle control on the ez command other then the bachmann work around?

THANK YOU
Robert

Will a 15volt 5amp power supply work on the ez command (not a booster)but power supply
Thank You
Robert

if your DC tains are in good shap you can change then to DCC by adding a decoder i have done this and they run good.
Robert

you can change your DC TRAINS TO DCC by adding a decoder i have done this and they run good.
Robert

Try cleaning the track where it slowdown and the wheels
EARIC

Thank you i have 12volt led that are good up to16volt.
Thank's again
EARIC

 I am putting a bachmann dcc decoder #44913 in my train and i need to know what voltage led to use do i use  a 1.5 or 12volt 
EARIC