Any suggestions on a track layout program for IPad?

Mr. Bachmann, is 24" radius EZ track available in bulk? or will it ever be in bulk?

Thanks Jim, as always you give the simplest yet all inclusive advise.
I haven't posted here since last winter, but when I did post this I was hoping you and a few others would be who responded. I live in the deep south so the winter is only time I can work on this Hobie. The warm weather keeps me and the grands outside as much as possible.

If I put a DCC decoder in a DC FT-A will it run at the same speed as my DCC FT-A? Can I run them in a consit using a Bachmann DCC controller?

timhar47, you have to put your picture on an outside site like photo buck and load it from there.

I pulled your picture off to my lap top so I could zoom in; is that all EZ track?

Thanks for the feed back. I don't plan on running anything modern so I thought I would be alright with 22" Thanks again

I am in the process of designing a new layout on a 6'x12' table using ez-track only. It appears that the largest radius sold in bulk is 22"; my question is will 22" work for "most" Spectrum loco's. I am planning on modeling the 1950's to 60's? I really don't want to buy track 5 pieces at a time.

I am looking at buying one of these any feed back positive or negative?

Thanks, I was looking in the wrong place.

I haven't seen a Bachmann turn table in their on line catalog.

Thanks

Does anyone know of a software that utilizes Bachmann EZ track sections?

Etbob, that's what they are they just broken and in pieces from a old 4x8 layout I had.

18"