Tank's

Hello, i serching for an technic to remove the decals (graphics) on loco tender.

Tank's
Luc

Hello, i serching to buy this engine (Roundhouse EMD Model 40) i found one shop but they sale only in USA.

Tank's
Luc
from Canada

Hello i have a problem with my controler, i lost the signal, the signal guage goes up and down and i totaly lost the control of the engine. I try it at any distance 1 feet to 8 feet.

Luc

Hello, i recently buy an Dynamis controler and bachmann 2-8-0 with sound, i would like to know if i can use all sound fonction buy now i can use only 9 sound fonction.

Luc

Hello, i would like to know if i can used an atlas under table switch machine with walters dcc-friendly turnouts.

tank's

Luc

Hello i planed to buy an software (model builder) from evan designs but i am not sure if it's work with Windos vista...Luc

No, on DCC no light it's like the control see nothing on rail, but on DC all work.

Luc

It's an FT unit from bachmann with dcc on board and no i don't know how make an reset (i used bachmann ez command)

Luc

Hello, yesterday during a short circuit i lost an engine, my dcc controler did not see it, i try to reprogram and nothing, i try to use it with analogue systeme and it's work but since the sort.. it refuse to work on dcc,

wath's wrong with this engine .......

Luc

Hello,
I planed to buy an MRC Ho scale synchronized sound DCC decoder (steam) 8 pin plug, with my DCC steam engine (8 pin plug) i used an Bachmann EZ command, can i used it right from the box.

Luc

Tank's to everyone,

Luc

The best way are to change all the turnout,(Atlas remote turnout)
Luc

I used 5 loco 3 steam and 2 diesel and the short append when backing into the siding.

Luc

That's exactly the situation, i will check for the turnout tight.
Luc