Thats very unfortunate since it was bachmann them selves that suggested buying these after I bought the locos with the different couplers, and yes i did mention they where the 2 shape rapidos on the locos. I can fit these to type to the t shape for now, its not perfect but it will do until I can find trucks that work, Micro trains trucks look the option, do all knuckle couplers work together? such as the Mark II that come with Bachmann locos, and Micro Trains ones?

Thanks

I looked at that conversion, they are only for couplers that have the same "tail" as the rapidos, that T shape. Bachmann EZ mate Mark II couplers have a circle at the end or an eye. If I went Micro Trains Line trucks with all the wheels and couplers, I would have to spend another $50, and would waste my dummy couplers, which is quite unfortunate since it was on the advice given to me 3 years ago.

Thanks, Im not sure if that will work, as the Mark II have a different end to the square end on rapido or dummy knuckle couplers

Any help would be great, do I have to replace the trucks? I would rather not, because dont trucks normally come with wheels and couplers as well?

Hi

Ill try and make this short, I bought a Bachmann set a long while ago, maybe 5 years or so, it came with a Sante Fe, the rolling stock came with Rapido couplers, that sort of have piece that clips on over the coupler and into the truck or on the body. Now while building a layout for it, I bought a GP7  and Consolidation, with plans on getting more rolling stock, I also bought quite a few EZ Mark II medium couplers, enough to do what I have and for future need, as I knew the 2 locos came with them already.

When I got them all, I went to convert the couplers on the rolling stock, and realized that being those clip on type I was a bit lost on how to do it, I actually "retro" fitted them to the rolling stock by using the clips still, but theres a flaw in this and that is that a simple bump or even the general vibration of the track causes the couples to hang down because the Mark II is thinner at the mounting point then the Rapido and the little metal arm to dig into the ties and obviously cause a derailment. I assume that theres meant to be a way of using a small screw and a flat bracket to hold it in place, but after 2 years of searching and hoping to see a solution I cant find anything. Obviously the new locos have this set up already. Just wondering if anyone can help me, how do I convert it, what do I need, and where can I get the things needed? Im from Australia, but dont mind ordering online.

Thanks