Hi All,
I recently purchased a new DCC-equipped Bachmann 4-8-4 Santa Fe. While I'm quite happy with the appearance of this loco, she wobbles heading down the track.
This doesn't seem like a problem that bad enough to send to Bachmann service, seems like she just needs a tune up job, perhaps just a re-quartering of the drivers.
My Question is: what tools should I obtain for this kind of work? What do I use for detaching the side-rods, itc. I'm already getting a NWSL quartering jig and have some small screw drivers, am I missing anything?
Regards,
scax330
I recently purchased a new DCC-equipped Bachmann 4-8-4 Santa Fe. While I'm quite happy with the appearance of this loco, she wobbles heading down the track.
This doesn't seem like a problem that bad enough to send to Bachmann service, seems like she just needs a tune up job, perhaps just a re-quartering of the drivers.
My Question is: what tools should I obtain for this kind of work? What do I use for detaching the side-rods, itc. I'm already getting a NWSL quartering jig and have some small screw drivers, am I missing anything?
Regards,
scax330