Thanks for all the details/ideas and suggestions

I am just wondering, is it possible to program locos to run and stop at certain points by using dynamis? If any one knows, please post the steps. I know how to run dcc locos manually  using dynamis. Is there is a way to program auto run and stops? or dynamis only for manual operation?
As a example if loco run in a circle track, how can I program it to stop at station for few seconds and go without manually stop? Is it possible to auto program speed?
Thanks

Hunt, thank you very much for your advise for solutions for dcc turnout in wrong position. I swap the wires and now working fine. Some how I had to swap different wires to  figure out which wires are  + and -. Good thing decoder didn't burn. my post is deleted by bachmann because I mention you have good knowledge than them.

Now I have another problem. Turnout do not respond some times to dynamis command. But same time locos respond very well. Before I had florescent lights and it cause some problems. not any more. When I reprogram 1 turnout separately from layout connect to the layout all turnouts work fine. After power off and start again lost respond. Some times work sometimes not working. Any solutions for this problem.