thanks for fast reply, it appears that i do not see any capacitor on top of the printed circuit as shown on the picture
its number is N860X6-PO2B is it normal
its number is N860X6-PO2B is it normal
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
N / Re: Connecting a N gauge GE dash 8 SPECTRUM DCC ready with a decoder
February 17, 2009, 06:28:21 AM #2
N / Connecting a N gauge GE dash 8 SPECTRUM DCC ready with a decoder
February 16, 2009, 02:30:29 PM
I have a BACHMANN GE dash 8-40 cw spectrum dcc ready ( BRAND NEW)and a digitrax dz123
i wish to connect them, until now i have removed the two copper caps that covered some of the contacts
I have then 7 holes to be connected from left to right: number 7,6,5,4,2,1,8.
first question is the any capacitor to cut as in sd 45 spectrum
second question: what are the advices for connecting the decoder, what order and special care so that I do not destroy everything
thanks a lot
i wish to connect them, until now i have removed the two copper caps that covered some of the contacts
I have then 7 holes to be connected from left to right: number 7,6,5,4,2,1,8.
first question is the any capacitor to cut as in sd 45 spectrum
second question: what are the advices for connecting the decoder, what order and special care so that I do not destroy everything
thanks a lot
Pages1