News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - peteajr

Pages1
#1
HO / Re: E-Z Command Decoder: Setting Address using Digitrax Zephyr
January 22, 2009, 12:42:01 AM
Thanks!  I'll give it a try
#2
HO / E-Z Command Decoder: Setting Address using Digitrax Zephyr
January 21, 2009, 03:16:26 PM
Just purchased and installed an E-Z Command decoder (item 44915) but am unable to change the address from the default 03.  Followed instructions in Zephyr manual but it just will not write a new address.
Any advice, insight?
Thanks
#3
HO / Re: 60532 HO Blue Cable Car : capable of using DCC?
December 16, 2008, 01:42:34 PM
Thanks to all for the replies.  I managed to take the trolley body off.  Installing the decoder in this looks pretty straight forward with a little careful soldering.  It has just the one interior light which I might replace with forward and reverse lights.   
#4
HO / Re: decoder installation in Brill Trolley
December 16, 2008, 01:34:46 PM
Thanks for the informative reply!  I will check out your ebay auction.
#5
HO / decoder installation in Brill Trolley
December 15, 2008, 01:39:26 PM
I have a Digitrax dz123 decoder that I'd like to put into a Brill Trolley.  Has anyone done this?  Is it simple or complex.  Any tips or instructions would be very helpful.
Happy Holidays (which is the trolley I want to put the decoder in)

#6
HO / Re: 60532 HO Blue Cable Car : capable of using DCC?
December 15, 2008, 01:35:58 PM
How difficult is it to install a Digitrax dz123 decoder into the Brill Trolley?  Is the Brill Trolley difficult to take apart?
Thanks.
#7
HO / 60532 HO Blue Cable Car : capable of using DCC?
December 02, 2008, 12:36:46 PM
is the motor installed in this cable car compatible with a DCC decoder?
Same question regarding the Brill Trolleys.
Thanks
Pages1