Thanks for the tip ! I got the problem solved .
My daughter printed it out for me and I got it after a few tries
Thanks for every ones help.
Bob

Thank you Hunt !

I followed the directions that my daughter printed out and the engine is reset to 3
BT

Oh Boy !

Looks like I better get a better "class" of friends...all my friends run there trains
with ZWs 

Thanks for the tip Ill see if I can find someone.

Bob T

Another problem...

I have a GE 70 Tonner that was purchased used.

The engine runs fine on a analog track,but does not respond to any
address on the EZ commander.
Is it possible someone assigned it to address on another dcc set up the the EZ Commander does not recognize ?

Is it possible to reset to factory address #3.

Thanks
Bob

Thanks for the help...I am sure its something simple that Im screwing up.
At least I got the 2 locos on the same address and my kid can run the 2 sharks nose to tail...I he wants it tail to tail he can figure it out on his own.
I have a headache !

Bob T

I was able to change the address from 3 to 1 and now I have 2 Locos
on the number 1 address.
The locos are BLW Sharks ones a D&H the other a Demonstrator.
They run fine nose to tail but I cannot figure out the tail to tail config.

Bob

I lost the CD that came with the original set.
I have more DCC engines than addresses now.
What is the procedure for assigning 2 engines to the same address
tail to tail ?
Thanks Bob