Quote from: RW James on May 01, 2012, 10:45:43 PM
I wouldn't do that. You'll end up damaging one or both of the locomotives. Have you cleaned and lubricated Thomas?

It really doesn't make sense that it shouldn't run better than that. Can you set up a test track with a dedicated power pack?

Never been run before. Brand new. Looks like it has a ton of lubricant. Runs well on test track in the back room. If i am running very low voltage/amps for the layout, would that be a likely idea?

Quote from: RW James on May 01, 2012, 07:14:57 PM
Well - not running or even sputtering running can be easily attributed to dirty wheels. But running 1 cm/min is just weird. On the other hand, I would love to be able to run my stuff that slow.

I would be ok with running it slow, but its the railroad museum. We run anywhere from 2-6 trains on the loops and 3 Back and forth trains. During the thomas event, i would like to show off a Thomas for the kids. But as he runs slow on the loops (which are best seen for the kids) and doesnt run at all on the Back and forth tracks, I am thinking i should just attach a knuckle coupler and have a locomotive push a train with Thomas at the front of it. If Thomas just needs time to heat up and run better, that might work.

Quote from: RW James on May 01, 2012, 03:49:52 PM
Could the layout possibly be DCC?

Have you tired running a known runner with the same settings? That is, if another HO DC locomotive runs well, and Thomas fails, then I would say there is something wrong with Thomas.

The layout is 100%to DC. Almost all the trains for the layout run properly. Thomas doesn't run properly.

I have an HO scale Thomas model. Unfortunately, it doesnt run on the layout I am using. When I put it on the track, it doesnt run at all on 1 track and extremely slow on the other tracks. Like it moves 1cm in 1min. Any suggestions? The layout I am using is the HO scale Layout at the Baltimore and Ohio Railroad Museum. Id like to have a working Thomas for this weekends Day out with Thomas event at the museum.

I am new to DCC and the diesel runs slow on my layout.

I have the old Split chassis F40ph from the old Patriot set. I was wondering if you can't install a Bachmann DCC into the F40ph, is it possible to put the new Acela HHP motor into the F40ph? Do they fit and connect properly with the F40ph motor housing?
Thank you very much.

Sincerely
Brendan Dobyns

Quote from: jonathan on July 03, 2011, 04:55:28 AM
Brendan,

You may have better luck joining and posting to this B&O specific group:

http://finance.groups.yahoo.com/group/Baltimore_and_Ohio/

Do you have photos of any of the light rail rolling stock?

Regards,

Jonathan

I have pictures.

Hello

My name is Brendan. I work as a volunteer at the Baltimore and Ohio Railroad Museum. I have been working on the HO scale layout there for quite some time.

I was wondering if anyone could either build or give me ideas to build a HO model of the MD Light Rail trains myself. We have realized this is something we need on the layout instead of the trolly in the layout. Any help would be appreciated. It would immediately go on as a donation and would be wired to run.

Thank you!