Thanls everyone for your suggestions.  I'm going to call Bachman on Monday.
God Bless, walt

Yes, I went to service and parts on this site and filled out the service request form twice.  Once last week and again this week but so far got no answer.

I'm a little confused.  My EZ Command system quit working about two weeks ago after only about two weeks.  I have reported this to Bachmann twice but with no responce.  I went to run the trains and when I plugged it in nothing happened.  I checked the outlet, The powersupply and both seem fine.  Is there anything else I can do?  Has any one else had the same problem?  I understand that these don't have the same warrenty as Bachmann
+- engines but don't they at least have some solution?  What do you think?  Thanks and God Bless, Walt

I'm planning to put DCC and sound in some of my Athearn F units and GP 35s any recomendations?  Is there a complete control and sound unit that will work or will I need two separate decoders?
Walt

to SteamGene,
I love the sound of the MRC decoder.  I was planning to buy an engine with sound that I could use with my DC setup but after being out bid on three on e-bay I bid on the decoder and an EZ comand unit.  The money I saved was more than enough to buy a set of Bachmann B&O Sharks (A&B units) with DCC.  So I'm very happy.  do you know if there is room for sonud in the sharks?
Walt

Well I couldn't find a place to post my question and ended up here so hope this is OK.  I have installed an MRC #001629 sound decoder in my Bachmann Spectrium class J.  It works but there are some problems.  I'm using Bachmann's EZ Command system and The volume on this engine is higher than I would like.  the chuff could be bgetter syncronized with the engine speed and some of the sounds aren't available.  Occasionally It whistles or gives one ot the other sounds on it's own.  Any ideas?
Walt