The old motor is toast and I was able ro remove the flywheels, but I'm not sure I can press on the flywheels onto the replacement motor shafts without damaging the motor. Also the old motor did not work with a decoder.
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / EMD SD45 replacement motor
September 05, 2012, 11:28:00 PM
Ihave several issues aboutbthis locomotive.
I need to replace a motor in an older EMD SD45 that I am converting to DCC. I can't find a replacement motor with the correct drive shaft coupling on the flywheels. Anyone have any idea where I can get one?
Also, if I am converting to dcc do I need the resistors on the motorr?
I need to replace a motor in an older EMD SD45 that I am converting to DCC. I can't find a replacement motor with the correct drive shaft coupling on the flywheels. Anyone have any idea where I can get one?
Also, if I am converting to dcc do I need the resistors on the motorr?
Pages1