Hello:  I just received a Bachmann log car, item 18351, 40', 1906-1935 version.  Some assembly required.
Anyone got any good ideas on how to get the tiny side "posts" seated into the tinier receptacles along the side of the car.  The "posts" don't fit.  I've tried using an Emory board to file an end down, but doesn't work too well, and the "posts" are easily broken.
I'm now thinking of just gluing the logs together and to the flat car.  then they don't need the posts to keep them on the car. I don't really need them to be reloadable. I can glue a few posts on the side for looks, but they won't hold anything.
Any ideas would be appreciated.  Thanks.

Piyer:  Thank you for that tip.  Touching the 9-volt battery to the track indeed got the locomotive running.  Switching the posts to opposite tracks ran the locomotive in the opposite direction.  My multi-meter reads about 9 volts in the tracks.  It also reads 9 volts in the little connecting metal pieces inside the female receptor (in the terminal rerailer) for the connector wire to the power pack. So, the locomotive works just fine!

This leads me to conclude there is something not right between the power pack (Bachmann item # 44211) and the female receptor in the track.  It is a very tight and stubborn fit, but I believe the connection is solid, but still no power in track.  I would like to cut the wire a couple of inches back from the connector and hold bare wire to the connecting metal pieces in the track.  This would test whether the male connector is making contact.  But I'm afraid this will jeopardize any warranty that may exist.

I will call the Bachmann service number on Monday, but in the meantime, any other ideas?

Update:  I got two wires and held one end of each to the separate posts of the D battery.  Then I carefully put the other ends in contact with the metal pieces in the terminal rerailer.  The train ran and completed several complete circuits of my small oval towing the three passenger cars without a hitch.  This proved to me that the track and locomotive are both in good condition.  There is some problem in the wire from the power pack to the track, and I suspect it is in the black plastic insert used to connect the wire to the track.

Just received my first train since a little kid:  The McKinley Explorer in N scale train set.  34" x 24"oval with E-Z track.  Carefully put the track together, and yes, some of them were a bit stubborn to get seated properly, but got it done.  Pushed loco and cars around to test connections.  All good.  The connection to the track plug-in from the power pack was also tight and stubborn, but finally seated it, turned on the power pack.  Red light shows power, but train won't run. Not a sound or inkling of power in the track.  Not sure how to confirm power in track, or if loco is the prob.
I'm totally new to model trains, this is my first step into the unknown.  Help, anyone?