News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - duker1246

#1
HO / Re: GS4 smoke generator
August 19, 2024, 09:45:55 AM
Thanks so much for the info!!! 
#2
HO / GS4 smoke generator
August 18, 2024, 09:58:11 AM
Greetings,
  I just bought the HO GS4 American Freedom Train for grandson but only has DCC instructions. He also has the HO GS4 Daylight Special with user instructions. Question is: does the DCC American Freedom Train have a smoke generator?
  Additionally, are Daylight instructions applicable for both models?

Regards,
The Duke
#3
N / Re: N Brill Trolley
May 03, 2021, 05:24:14 PM
Good luck Steve!!
Duke
#4
N / Re: N Brill Trolley
May 03, 2021, 12:40:58 PM
Never looked at it that way. I have both poles up since no way to raise and lower the poles when direction changed. And besides if auto reverse than not enough time between next run start to lower one or the other pole.
#5
N / Re: N Brill Trolley
May 03, 2021, 08:04:24 AM
You are welcome!
My layout is set in 50's-60's era so I am using some old style brown poles that have the catenary wire arms so I have the poles in up position like they are active when running.
#6
N / Re: N Brill Trolley
May 02, 2021, 08:40:46 AM
From the bottom of the wheels to top of room is 1" and from bottom of wheels to top of the cable arm is 1 1/2". Be advised that the Hayes bumper is not where the trolley actually stops; but further up because the B sections are not powered.
#7
N / N auto reverse track
May 01, 2021, 03:20:24 PM
Greetings,
  With the Auto Reverse track can the 2 5" 'B' sections be replaced with the 2 5" 'A - B' sections so that the Brill Trolley will stop closer to the Hayes Bumpers? This would allow me to have longer runs than if the Trolley stopped before the 'B' track.

Regards,
The Duke
#8
N / EZ track to other track transition
November 08, 2020, 03:28:38 PM
I bought the Bachman N motorized turntable and it works well. However, the tracks will not line up with the Walthers roundhouse. Is there a transition track I can use from Bachman to another track? My thought is to buy another turntable that will work with the roundhouse. Basically - an engine comes off the EZ track and transitions to the other turntable track which engine in turn ends up in the roundhouse.

Thanks,
The Duke