I have a new Bachmann On30 Stearns-Heisler I just received. DCC on board in the green box. No sound installed.

I cannot get it to move on DC (MRC Tech 3 9500) or on DCC (NCE PowerCab). It does respond at its DCC address and the lights will switch on and off.

1) I checked it on the programming track and I can read and write CVs just fine -- I changed the address to 5 and again the lights at Address 5 work fine.

2) I did a factory reset via setting CV8 to 8 and it reset the address to 3. After the reset I also re-checked the CVs 209-213 as indicated on the Bachmann document to ensure they had the correct values after a reset (they do).

Any ideas on what else to check for?

Love this little engine...now if I can just get it running....

Thanks in advance!
Michael