I have a small screw driver blade on my knife. Using it I could open up the joiner and loosened it up on the track and remove it. It was not damaged nor the track and could be reused.
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / Re: To work with 44912
April 05, 2016, 06:45:19 PM
How can you insulate a curve track without removing the interconnecting pins?
I have done this and I get a short when the locomotive passes over it. The light on the controller goes out.
I have done this and I get a short when the locomotive passes over it. The light on the controller goes out.
#4
General Discussion / To work with 44912
April 04, 2016, 05:24:41 PM
To work with 44912 reversing control you have a straight insulated gap with terminal. Why do you not have a curve?
What is an easy way to remove the connecting pins to insulate a track?
What is an easy way to remove the connecting pins to insulate a track?
Pages1