ok I will thanks

I have a bachmann dynamis control system and a ane smart switch and I'm trying to program them to operate a switch track, I do what the instructions say but it won't program it, the ane is #a003 any help would be great
thanks Tom

I've worked on heavy equipment and know gladhand couplers are thanks 

I need a little help I'm just starting out with ho stuff and I'm using glad hand couplers what is the difference over the shank long couplers and long center shank coupler's
thanks Tom

what I bought was dynamis #36505 I thought the infrared system would be the best my bad the probox is another $200.00 maybe I should sell what I have and go with the nce system any thoughts

Tom

and where will the other receivers plug into

hate to ask what is the part number of the receivers you are using

I'm just wondering how and where to set the mirrors have you seen a set up with mirrors? I'm thinking about getting away from this system and go with a nce system seen some good reviews on the nce I thought after reading on the bachmann systems with the infrared system was a great choice, if I knew the bachmann was this hard with the infrared I may have went with an nce system any thoughts.

thanks Tom

that's interesting

yes I have the Dynamis system

I have a bachmann e-z command control system is there anyway I can boost the signal from the hand set to the receiver I get 4ft away or to the side and it loses the signal or is there another system like nce that won't lose the signal

thanks Tom

Ok I've read some bad reviews on this system I am just getting back into trains after 25 yrs so this dcc is new to me I know I got a lot to learn thanks for the help
Tom

I bought a bachmann ez command dynamis the problem I'm having is if the remote is not pointed straight at the power pack it loses the signal and stops and sometimes if I'm more than 6 ft away it will lose it any help
thanks Tom