Hi all,
I have two Bachmann GE Center Cab 45 Ton Switchers, both were running at about the same speed through the speed range, however one was 'jerky' when running less than 30 (128 range), so I tried to alter the CVs 54 and 55 to try to improve it.
Unexpectedly the loco now runs very slow at low speed, eg I now have to set the speed to 45 or 50 to have the same speed as the other loco on 30.
Could you please advise the original values set for CVs 53 to 55 as a reset to factory settings (using CV8 = 8 ) still does not fix the problem.
Many thanks
Rob
I have two Bachmann GE Center Cab 45 Ton Switchers, both were running at about the same speed through the speed range, however one was 'jerky' when running less than 30 (128 range), so I tried to alter the CVs 54 and 55 to try to improve it.
Unexpectedly the loco now runs very slow at low speed, eg I now have to set the speed to 45 or 50 to have the same speed as the other loco on 30.
Could you please advise the original values set for CVs 53 to 55 as a reset to factory settings (using CV8 = 8 ) still does not fix the problem.
Many thanks
Rob