I just bought a locomotive in On30 scale which is a 2-6-6-2. I am wondering why there are no parts available at the inline store.

I just received two brand new bachmann lighted cabooses. They are identical but one of the m shorts out my track. I can't see any obvious difference between the two. Any idea what is causing the problem.

I should have mentioned that I also am running a 4-4-0 that is new and it runs fine. I have noticed that one of the 4-6-0 will try to creep even when the EZ DCC control is at zero.                     

I'm relatively new to model trains. I have a couple of 4-6-0 locomotives that I bought new on E-bay.
After several hours of operation I noticed that both engines were not running as fast as they did initially. I cleaned the track thoroughly thinking that  was the cause but it didn't make any difference. I also cleaned and inspected the locomotive wheels. Nothing seemed to make any difference. Can any one tell me what the possible cause may be?

I've ordered a height gauge. What if the couplers are at the same height but still come uncoupled?

How do you adjust a coupling if it isn't the right height? Are couplings adversely effected by track imperfections?

I appreciated any help you can give.

My locomotives and rolling stock are all Bachmann items in On30 scale.

My locomotives are 2-6-0 and 4-6-0

I'm having a little trouble with my couplers staying hooked up.

Can anyone make a recommendation as to the best magnetic coupler to put on my cars.

I purchased a used freight car that doesn't have the original Bachmann trucks. What is the standard truck that comes with a new Bachmann freight car?

If you install a soundtraxx decoder in a Bachmann 2-6-0 locomotive do you have to go through the process of a special programing track section?

where is the best source of properly scaled buildings and accessories for a On30 layout?

any way to keep it from happening?

I recently installed a sound decoder in a Bachmann 2-6-0 locomotive. All of the sounds appear to be working as they should.
Problem is that I have no speed control in forward and the engine runs at one speed.  Also it runs faster in reverse and I do have some speed control.
I don't think I have reversed the motor leads. Any one run into this problem before?

When I start up my EZ DCC command console it jumps to position #1 and several of my switches jump from one position to the other.
This seems to be particularly true after a derailment and I have to turn off the console with the switch on the back.
Anyone know why this is happening?

I am about to set up a train track board. How do you activate the Command Switches? Do I assume that they can be controlled by the EZ Command console?