Jerrys,

I actually pull the table out. Now I have it wired stray to the NCE Power Cab. I did at one time see the motor spinning in a jerky motion. Like it will turn a half a turn then stop, the when I had push one rail then it turn for another half a turn. I then pull the table out of the layout and using a jumper wires I have it connected to the Power Cab. I'm convince that this table only runs DCC if it connected to the Bachmann system only. This is just like a bate on the hook. I'm just going to run the table using DC.

bapguy,

Yes I did, I try 03, 003, and 3, nothing works. I had reset cv8 to 8, which will reset to address 3. I'm not sure why it does not react to the command? Or does not want to communicate to the NCE Power Cab? This is a brand new table, new decoder (44926), and new NCE.

Hi, I need help from somebody outhere that has had succes making the Bachmann DCC turntable to work with an NCE power Cap or MCR. I alrady know that the table works on DCC if is connected to the Bachman system. Connecting the decoder and power the # 4 track, and using NCE or MRC does the table works. My only works at DC and not with my NCE system? I had place  Bachmann decoder, power the # 4 track, there is nothing on my tracks except the table. I call loco 003, then nothing happens it is like nothing is connected to the table?

I had installed the Bachmann decoder # 44926, also the DCC power is to the # 4 track. My DCC system is bran new- NCE Power Cab. I have follow this instruction, and there nothing on DCC. I'm not doing the same thing the guy on youtube, i'm not buying the E-Z Command control. What ever happens  NMRA standard?

I aready try that. The turntable just does not move at all on dcc. I have the speed on my NCE uop to 28. If I go and touch on the 4 track connection it moves a little then stop, I heve to touch on one of the rail on the track (#4) and it moves a little. I had connect the DCC straight to to # 4 rail and it does not move. II had place it back to DC and it works. I'm hope that I can run DC to turn the table and DCC to run power to the track. I hope that is nothing wrong with the track?

Ok, I may sound like the other guy that had problems with the turntable. I'm able to run the table with dc, but not with my DCC (NCE). Looks like the only way to run this turntable is with a complete Bachman system.