Those are exactly the same instructions as I have followed to the letter before, maybe I have a defective unit. 

I have an all-Bachmann DCC layout with DCC turnouts, turntable, etc.  I upgraded to the Dymanis, which runs all my locos and the turntable fine.  However following all the instructions, to program and switch the turnouts with the Dynamis, it neither switches them nor programs them.  My DCC Command Controller does, but not the Dynamis.

I made a video of a simple layout with one DDC engine and one DCC turnout, demonstrating how the DCC Command controller ran the gear, then attached switched the layout to the Dynamis.  Loco worked, accessory turnout - nothing. 

What's the secret?

Good tip - thanks, and that does work every time with my DCC Command Controller.  BUT no joy with the Dynamis.    I have 12 Bachmann DCC turnouts, so obviously with the DCC CC, I have some limitations with the turnouts.  I made a video for Bachmann showing an engine and one turnout connected first to the DCC CC, then the same isolated track attached to the Dynamis so they could see that the Dynamis ran the train but would not switch or program that turnout.  They said they would get back to me; that was in early June.  I have sent them three follow-up reminders, but with no answer.

Did you ever get an answer or a solution?  I too have the complete Dymanis configuration.  Runs trains and turntable fine, but none of my turnouts - so useless.  Stuck.  Have asked Bachmann, with no answer.  Tempted to march into their HQ in PA with my gear and demand they make it work.  But you may have the answer and save me the drive.
PLEASE REPLY.

I have a fairly extensive 100% Bachmann HO DCC 5' X 8 ' layout, with reversing loop, motorized turntable w/ Tidmouth Shed, main, siding, a/d track, etc. (landscaping to come later), but cannot see all my DCC Turnouts and therefore am trying to find information on adding signal lights to my Bachmann DCC Turnouts to avoid derailments.  Do you have any recommendations on how to wire in functional signal lights onto the 44130 and 44131 EZ Command DCC Turnouts?

Jim,

I have a fairly extensive 100% Bachmann HO DCC 5' X 8 ' layout, with reversing loop, motorized turntable w/ Tidmouth Shed, main, siding, a/d track, etc. (landscaping to come later), but cannot see all my DCC Turnouts and therefore am trying to find information on adding signal lights to my Bachmann DCC Turnouts to avoid derailments.  Do you have any recommendations on how to wire in functional signal lights onto the 44130 and 44131 EZ Command DCC Turnouts?