Hi
I have a Digitrax DH126 loco decoder with unknown address and would like to use it on E-Z.
I would like to give a new address, say  #3, and reset the cvs to default.
How do I go about the reset to default ?
Thanks

Charles Harris

Hi
I have a loco decoder ( Digitrax  DH126)  with unknown loco address.  With EZ Command how do I reset CV8  to give defaults for all CVs and loco address to number 3 .   Is there a Arduino solution to use a 16x2 lcd display, to show result?

With the decoder out of locomotive (do not want to run the motor)  how do I set up wiring to achieve the reset.   Using breadboard is it  Tk A to  Red on decoder and Tk B   to blk on decoder ?  I am being a bit simplistic here, old brain.
Thankyou

Charles Harris

Hi

What options do I have for a HO    H16--44  to reduce the gear ratio and increase traction, for a specific gradient on my layout, about 3%.

Is there a lower ratio gear set available, or complete   trucks with gears  off another model.   Recommendations ??
Is there somewhere that lists gear ratios on different models ?


Thankyou

The square front on the Gs electrics.  Can that be purchased as a spare part ?