Thanks again, excellent work by George.

Thanks Bill, your number is the one, must learn to check my typing before sending. Do these not come with any instructions etc., can't be to difficult to dismantle.

Just a quick question, have just picked up a ls street car 93928, date stamped inside end of box 6th Sep 14, looks unused, when I tested it only 1 of the running lights worked and none of the interior, was there a problem with the lighting on these ?

Thanks Kevin. The board is as you said, no wires but lots of components, it has GX83-V2 on it. There is also a bag with another board that has a whole bunch of wires on it, but I don`t have the "dummy" plug, I guess I need to find one.

I have just aquired 2.6.6.2 dcc equipped. Bare with me, I know nothing about dcc or how to tell if it is fitted. I onlyuse a standard dc controller. It runs fine on my test track, I set all the switches as per the handbook, haven't got the lights working yet. I would like to fit a soundcard, I have been using "my locosound soundcards" but I believe they don't work with dcc. If I have dcc do I remove it or do I give it a go?

Thanks

Firstly just want to say hello from over the pond in England. I collect American steam locos, mostly they don`t get to run at the moment, I do have a test track and am working on


















Hello from England, I have a 2-6-0 no.81497 Rio Grand Southern and I am going to fit a `MyLocoSound` card. All I need is to get is a connection to the motor feed wires. The tender has 2 sockets on it, 1 is a 4 pin and has 2 wires from the wheel pickups and the other is a 2 pin not connected. The loco has a 4 pin plug and a 2 pin plug. Can anyone tell me what the pins on the loco plugs are connected to in the loco ?
regards, Dennis.

Hi, i have just aquired a new unused Climax in demonstrator livery but it has the original rear drive, anyone know where i can get the modified one ? I am in England, thanks.