Can this coupler replace the coupler on Acela  Passenger cars?

    I was more concern with Bahmann Controller's. Is Dynamis the only Bachmann
controller?
bernie7787

 :-Xhow do diconnect these couplers ? Bachmann Paper Work leavea you out in left field---
nothing. I now have two cars couplered together and have no idea--HELP
bernie7787

New DCC Turnouts ---What controler do you use? Dynamis??

Dynamis User Guide Page 23.Dose not include Digital Command
in other products that can use with Dynamis.
                                                 bernie7787

Dynamis User Guide Page 3
  DCC engines only. Damage may result if dc  engine placed on a track
  powered by Dynamis.
                                  bernie7787

SvFait,
   Could you send me your PDF on Dynamis.
       THANKS,
                      [email protected]

Quote from: Jim Banner on May 01, 2008, 06:57:54 PM
Bernie, I am sorry that no one has tried to answer your questions.  But after reading your post several times, I believe you might have better luck with getting an answer if you could go a bit further explaining yours questions.

QuoteHAVING TROUBLE USING THE HAND SET.

What sort of trouble are you having with your handset?   Do you keep dropping it?  Are the buttons hard for you to push?  Do you have trouble turning the knobs?  Is the display hard to read?  Is there something that you don't understand?  Is the cord too short?  Is it too dark in your train room?

QuoteINSTRUCTIONS LEAVE ALOT TO BE DESIRED.

Is it the instructions in general that you don't like?  Is it just the instructions for the handset that you are having problems with?  Are the instructions too simplified and you feel they should be more comprehensive?  Or are they too inclusive and you feel they should be simplified?  Do you have an understanding of DCC?  Do you feel the instructions should should explain what DCC is all about?  Can you give any specific examples of what in the instructions is confusing you?

QuoteI NEED HELP.

I am not an expert on the Dynamis but I suspect that those who are would be more willing to try to answer your questions if they could understand what they were.  There is also the possibility that they are turned off by your use of all capitals.  On line, using all capitals is the equivalent of shouting and is often seen as a sign of rudeness.

Quote from: the Bach-man on May 01, 2008, 11:04:22 PM
Dear Bernie,
Sorry I missed your question the first time through. However, Jim is exactly right- can you be more specific?
Thanks!
the Bach-man

Sent new question . I hope more to the point as you suggested

Direct Question.
Receiver LED -Normal operations- Left hand - Constant  light indicates
                                                     power to headset. mine flashes green???
                                                     Right hand - flashes on receipt of handset
                                                     signals. mine flashes a slow yellow/brown
                                                        Page 5 user guide
                                                      Did test track for short -Checks out fine.
                                                      I think this interfering with operation
                                                      with my headset.
                                                       Any ideas??
                                                       bernie7787

HAVING TROUBLE USING THE HAND SET.INSTRUCTIONS LEAVE ALOT TO BE DESIRED. I NEED HELP.

Bachmann Turnouts run on ac. Can they be change to DC with the use diode ?  Can  a  Signal direction light connection be used with the turnout by using a diode to change ac to dc ?  Sorry I'm talking about Bachmann EZ Track System N/S.Need some Ideas.
                                               Thanks,
                                                             bernie novice@66
                                                                 (also dumb)

I need to know if at all possable to wire switches with Led R/G Signals?