Well I guess you can tell that I'm a rookie.
Thanks for the advice.
KEITH>
Thanks for the advice.
KEITH>
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
HO / Re: Straighting the curves
September 12, 2011, 11:50:53 AM
I'm confused.
I'm using a long string of 9" long 18' radius curves to go a length of ten feet along the edge of a wall. The pieces obviously face different ways one after another. Before I get to the corner I want to straighten out for two feet. Would I use an 18' radius half curve to perform the straightening, so I can then attach the two feet straight track?
If not the half section, then which?
I'm using the snap track.
Thanks for any help and advice.
I'm using a long string of 9" long 18' radius curves to go a length of ten feet along the edge of a wall. The pieces obviously face different ways one after another. Before I get to the corner I want to straighten out for two feet. Would I use an 18' radius half curve to perform the straightening, so I can then attach the two feet straight track?
If not the half section, then which?
I'm using the snap track.
Thanks for any help and advice.
Pages1