News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - sagegraqy

#1
On30 / no lubrication info?
January 06, 2014, 10:54:27 AM
Hi,  I am new to 0n30 and bought a 4-6-0 with sound - I noticed there is no lubrication or basic disassembly info with this engine?

Can I download info?

Thank you, Ray
#2
I understand polarity reversal caused from a crossover when four turnouts are added to form a oval.  Seems like the simplest thing to do is isolate the sections of straight track between the turnouts?  I am wondering what is the best way to electrically control these isolated pieces of track?  Would a DCC controller help at all?   what are "loop controllers?

Ray Brooks   [email protected]
#3
HO / Re: Newbie question about turnouts
November 15, 2013, 08:51:00 AM
I too am trying to have a oval with a figure eight crossover and four turnouts.  It seems to me that the simplest thing is to isolate the sections of straight track between the turnouts?  I am wondering what is the best way to control these sections of track?  would a dcc controller help at all?  What is a "loop controller?

Thank you
#4
On30 / new forney has buzzing noise
November 02, 2013, 01:16:10 PM
I just received a new on30 Forney and found a rather noisy (buzzing) sound when slowly starting to move.  If I hold the tender or put resistance the sound goes away.  Seems like some part vibration.  I am planning to install sound so I removed the tender housing and ran it.  Buzzing still occurred.   sound seems to be coming from the rear (tender area)

Any help?  has this been a common problem?