I would like to add a dcc decoder to this engine/tender.

Does someone have instructions on this procedure, if available?

I use the basic Bachmann DCC controller, is there a list of functions for the controller?



Thanks...Tim

Thank you, I appreciate your helping.

What with or how do you power the E-Z track remote turnout solenoids.

My DCC controller has female plugs for; DC connection; for track power and a loco-link.

I have five turnout switches which I can gang connect (via the left sides]; with the green control wire going into the top connection; & power goes to the left hand side connection.

How much power is needed for each switch?

Is there a wall wart to handle this function?

Thanks...Tim