The chip that was in the engine before had fried, so I used a dummy DC plug for the last 2 months before the wires ripped out. Since that just completes the circuit i don't think you can put them in the wrong way, i could be wrong. The decoder from the Dash 8 was a Digitrax decoder that has no wiring on it, just 8 pins on the bottom, but does indicate where pin 1 is. Not sure what the item number is.
Okay, since there is no diagram then I will just change over the wires in the motor. I wanted a new motor inside anyway so a perfect time to swap it out.
Okay, since there is no diagram then I will just change over the wires in the motor. I wanted a new motor inside anyway so a perfect time to swap it out.