I put the DCC decoder in the body of Henry. It was a tight fit , but I didn't use a really mini size decoder. If I was going to do it again I would go with a TCS M1 decoder.
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#31
Thomas & Friends / Re: Is there a way to make Thomas locomotives DCC?
January 02, 2011, 10:40:09 PM #32
Thomas & Friends / Re: A small problem with Bachman Thomas
January 02, 2011, 10:36:31 PM
It could be that you broke a wire someplace.
#33
Thomas & Friends / Re: James has a problem in your engine
January 02, 2011, 10:34:58 PM
I had the same problem with Henry. My son ran him today and one of the brush holders got hot and came lose in the motor. I did figure out a way to repair him, but was disappointed this happened to a train that is a week old.
#34
Thomas & Friends / Re: Is there a way to make Thomas locomotives DCC?
December 28, 2010, 08:11:54 PM
I added DCC chips to my Son's Thomas and Henry locomotives. Thomas was an easier job because he has much more room for the chip then Henry.I don't have any links, but there are a few sites that will install a DCC decoder in a thomas and friends engine for you.