Problem--Although all the sound and light functions work fine, the motor only works intermittently and unpredictably.
The connections on the board are all tight and the motor connections seem tight. When it does run any change in direction or CV will shut the motor down.
I have tried resets from CV 8 and 30 and consist is off.
Thanks for any suggestions
Dan

I need to remove the shell from a new RS-3 as the decoder is not running properly. Instructions please.
Thanks
Dan

I recently bought a new red HO 70 tonner with DCC on board. I cannot change the address from 3 using either MRC PA or NCE systems, programming on the main.
Last year I sent another new unit back for the same  problem. The tech called to see what address I wanted and was surprised that I was having a problem. Problem solved.
Question--what did you do to get a new (#50) address?
I also bought the new cream/gold scheme and changed the address ok.
Thanks Dan

It looks like the new color scheme for the 60611 GE 70 tonner is copied from the Salzburg short line scheme.  Is it? What great news if so! Hard to believe that this didn't happen until after i had painted the undecs I bought.
Dan

What size tender comes with the ten wheeler? Looks like the small one. I'm thinking of using the medium coal tender with the 4-6-0 if a speaker/decoder will fit better. I have a Lok Sound decoder and even substituting the 3/4" speaker, there is not room. I'd rather not cut out the board. How long is the medium tender? Are the board and harness included in tender-only purchases? Anyone else tried this?
Thanks Dan

I installed a TCS MC-2 with short harness in a brand new HO 4-6-0 with DCC plug. The decoder **and** two wire plug immediately burned. Since this is a supposed to be a DCC-ready product what is the procedure to get the loco fixed?
Thanks Dan