Hi all,
Interesting problem popped up today with my Dynamis system.
Used it earlier today and all was as it should be. Then came back a few hours later, powered up the command center, turned on the controller and SURPRISE all the loco addresses were gone !
If I enter an address for a particular loco, that loco responds as it should with no loss of the CV' s as I had programmed them(except speed steps). But I can no longer scroll through to select the loco I want, their assigned names/ addresses are gone. Also, the speed steps for all locos have reverted to 28 instead of the 128 I had them set at.
I always hit Stop, then power off the hand set and lastly the command station.
Is this operator error or a quirk with the system? Is there a simple recovery process, or must I reprogram all my locos?
Any input will be Greatly Appreciated !!
Thanks !
Rick in NH
Interesting problem popped up today with my Dynamis system.
Used it earlier today and all was as it should be. Then came back a few hours later, powered up the command center, turned on the controller and SURPRISE all the loco addresses were gone !
If I enter an address for a particular loco, that loco responds as it should with no loss of the CV' s as I had programmed them(except speed steps). But I can no longer scroll through to select the loco I want, their assigned names/ addresses are gone. Also, the speed steps for all locos have reverted to 28 instead of the 128 I had them set at.
I always hit Stop, then power off the hand set and lastly the command station.
Is this operator error or a quirk with the system? Is there a simple recovery process, or must I reprogram all my locos?
Any input will be Greatly Appreciated !!
Thanks !
Rick in NH