Hello all on this forum,
I am new to model railroading and in the very early stages of building my first layout. I have the Overland Limited train set that came with a DC Union Pacific 4-8-4. My question is I purchased an EZ Command Control unit off ebay and when I hook it up my DC engine makes a high pitched squeal and at first would not run all the time, but now just sqeals and will not run t all and I am using channel 10 which is supposed to be for DC. If I hook up my DC power supply the train runs perfectly.
I have not been able to try a DCC engine yet as I just bought my first one and it is scheduled for delivery on Wednesday.
Is it normal for some DC engines to act this way on DCC?
I have learned a lot over the last couple of months from this board but could not find any info on this type of problem.
Thank You in advance for helping out a newbie.
John
I am new to model railroading and in the very early stages of building my first layout. I have the Overland Limited train set that came with a DC Union Pacific 4-8-4. My question is I purchased an EZ Command Control unit off ebay and when I hook it up my DC engine makes a high pitched squeal and at first would not run all the time, but now just sqeals and will not run t all and I am using channel 10 which is supposed to be for DC. If I hook up my DC power supply the train runs perfectly.
I have not been able to try a DCC engine yet as I just bought my first one and it is scheduled for delivery on Wednesday.
Is it normal for some DC engines to act this way on DCC?
I have learned a lot over the last couple of months from this board but could not find any info on this type of problem.
Thank You in advance for helping out a newbie.
John