It is stated in frequently asked questions on E-Z Command '
Can I operate my existing non DCC locomotives on my E-Z Command System?
Absolutely. Bachmann E-Z Command® supports the operation of one non decoder locomotive at a time. When button 10 is pressed the speed control and direction buttons control the non decoder equipped locomotive.
Alternatively you can plug the AC power pack into a Bachmann analog throttle and plug the throttle into the E-Z command using the supplied cable into the E-Z Command. When this is done the analog throttle controls the non decoder equipped locomotive and Button 10 controls a digital locomotive with the address of 10
If you do this, are you running a risk of damaging the non-decoder equipped locomotive in order to save a few dollars?
Also would the risk of damage be greater running DCC equipped and non equipped at the same time?
Tom
Can I operate my existing non DCC locomotives on my E-Z Command System?
Absolutely. Bachmann E-Z Command® supports the operation of one non decoder locomotive at a time. When button 10 is pressed the speed control and direction buttons control the non decoder equipped locomotive.
Alternatively you can plug the AC power pack into a Bachmann analog throttle and plug the throttle into the E-Z command using the supplied cable into the E-Z Command. When this is done the analog throttle controls the non decoder equipped locomotive and Button 10 controls a digital locomotive with the address of 10
If you do this, are you running a risk of damaging the non-decoder equipped locomotive in order to save a few dollars?
Also would the risk of damage be greater running DCC equipped and non equipped at the same time?
Tom