I'm building my layout with Bachmann EZ track and pretty well have the track laid. I have a few elevations to finish as well as a tunnel. I have two questions:
[1] On the EZ track turnouts 44561 & 44562, the switch unit itself that the user actually depresses to actuate the switch mechanism --- Are they capable of 'pairing' together? By this I mean only for the red feeder wire that supplies power. As far as the switching goes, I will want them to remain independent. They will join together on the sides, but I didn't want to try without consulting experienced modelers first.
[2] Once I get everything where I want it, I was thinking about fastening the track permanently. Would glue here and there be sufficient? I notice the tiny little holes at each end & center of the ties, but didn't want to deal with that.
Any advise/suggestions are always appreciated.
Lonnie
[1] On the EZ track turnouts 44561 & 44562, the switch unit itself that the user actually depresses to actuate the switch mechanism --- Are they capable of 'pairing' together? By this I mean only for the red feeder wire that supplies power. As far as the switching goes, I will want them to remain independent. They will join together on the sides, but I didn't want to try without consulting experienced modelers first.
[2] Once I get everything where I want it, I was thinking about fastening the track permanently. Would glue here and there be sufficient? I notice the tiny little holes at each end & center of the ties, but didn't want to deal with that.
Any advise/suggestions are always appreciated.
Lonnie