News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Programing a new address problems with EZ command

Started by NMWTRR, July 22, 2009, 09:49:49 PM

Previous topic - Next topic

NMWTRR

I recently purchased a EZ Command DCC controller and one HO Bachmann DCC locomotive.  I followed the instructions that came with it and I tried to change the address but could not get it to change.  I tried it with another Bachmann DCC locomotive and had the same results.

Any suggestions?

the Bach-man

Dear NM,
When you follow the directions, think "Control, Alt, Delete".  Since the locos are on address 3, press the 3 button, and hold it down while you press stop. Release both at the same time. Then press the new address, and the loco should move a little to let you know its accepted the new address.
Have fun!
the Bach-man

Robertj668

NM
Did you figure it out yet?
You tube has a little video on how to do it. If i remember.
Let me know if you need the link
Robert