News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Bachmann Spectrum Dash 8-40CW decoder installation.

Started by jwoj69, April 08, 2009, 09:03:08 PM

Previous topic - Next topic

jwoj69

I had found a very good step by step instructions on how to install decoder to Bachmann spectrum diesels. See:
http://www.bachmanntrains.com/home-usa/board/index.php/topic,7064.0.html
I did my Dash SD-45 no problems. I'm starting my Dash 8-40CW and i have notice that the resistor showed on beginning of installation is missing. It should be cut off.
is this resistor located somewhere else or it's no longer need it?
Please help
jack

fieromike

No longer needed.  I believe it was for RFI noise suppression.

jwoj69

Quote from: fieromike on April 08, 2009, 09:17:55 PM
No longer needed.  I believe it was for RFI noise suppression.
You are life saver. I had couple mishaps, where decoder was destroyed (Conversion of none dc chassis). I did not want to loose another one.
Thanks again jack

TCWORLD

You should get TCS decoders, they have a no quibble money back guarentee, and are virtually impossible to destroy - Ive blown up one of mine (smoke, melting, etc.) several times, and it still works perfectly.
Tom

-~The time you enjoy wasting is not wasted time~-

jwoj69

Quote from: TCWORLD on April 09, 2009, 06:07:08 PM
You should get TCS decoders, they have a no quibble money back guarentee, and are virtually impossible to destroy - Ive blown up one of mine (smoke, melting, etc.) several times, and it still works perfectly.
Would You happen to know good source for them?
jack

TCWORLD

I know sources in the UK, but i'd have to look for ones in the US - there will be loads, just a matter of looking.
Tom

-~The time you enjoy wasting is not wasted time~-