News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

installing DCC unit in 3-truck SHAY

Started by lexgeys, March 10, 2008, 11:26:44 AM

Previous topic - Next topic

lexgeys

Might sound like a stupid question, HOW do I open the water tank assembly to put a decoder in this engine???

Have my tools ready when answer arrives
Thanks
Lex Geys

WoundedBear

It's not an overly difficult task.....just a tad fiddly.

1...Flip your shay upside down in a foam cradle.

2...Gently remove the ladder from the rear of the tank.

3...Remove the rear truck.

4...Disconnect the drawbar from the main chassis, and remove the electrical plugs from bottom of tank.

5...Remove the screw that holds the tank to it's frame. There are two "clips" at rear of tank and a screw towards the front.

6...Gently lift the tank off the frame.

7...You will see the 8pin socket on the circuit board.....remove the jumper plug that is installed from factory, and install you decoder.

Reverse steps for reassembly.

Hope this helps.

Sid

richG