News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Extending ez track turnout wiring

Started by Axle, August 18, 2017, 10:17:48 AM

Previous topic - Next topic

Axle

Newbie with ez track wiring.
I am short a couple of feet of green wire on three of me ez track turnouts but I done what
To purchase the green 10' extension wire the Bachmann sells. Can I splice the three green
Switch wires with different wire and what gauge would I need.
Any suggestion would be help full.
Thanks
Axle

Len

In the past I've picked up cheap 3-conductor extenstion cords (16-3), cut the ends off, and spliced them in using wire nuts.

Len
If at first you don't succeed, throw it in the spare parts box.

Alez

Hello Len
Is this 3-conductor exstension cord the same as telephone wire.
Axle

Len

Quote from: Alez on August 18, 2017, 03:23:16 PM
Hello Len
Is this 3-conductor exstension cord the same as telephone wire.
Axle

No, it's a power extension cord something like this:



Cost is around $6.00, and with 8ft of wire you can extend a number of turnout controls.

Len
If at first you don't succeed, throw it in the spare parts box.

Alez

Len
That's a good idea I will check it out.
Thanks
Alez

Alez

Len or anyone
Will telephone cable work just a will as 16-3 cable?
Alez

Len

Stranded telephone wire is usually 24ga, which is a bit on the light side for the current involved. Solid telephone wire is 22ga, but is prone to break inside the insulation when flexed. Personally, I only use stranded wire, and nothing smaller than 20ga.

Len
If at first you don't succeed, throw it in the spare parts box.