News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

convert std. EZ track to auto-reversing track

Started by weaselbear, May 18, 2015, 02:09:50 PM

Previous topic - Next topic

weaselbear

Is there a way to converts EZ track to reversing track??  ie: the non-standard sizes such as half track straight and curved
and  other short pieces?  Also full length curved other than the 18" Radius

ACY

If you want to use non-auto reverse track you would need to do one of two things. Wire all interior track pieces identical to those which are labeled A on both ends or you can run the appropriate wires the wntire length of the run from one stop point to the other. You must ensure all wires are going to the correct rails or else you will release the magic smoke. IFF you consider yourself to be good at this sort of thing then you should be able to wire it up without any issues however if this is a weak area for you, then you may want to bite the bullet and just make due with actual auto-reversing track.