News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Decoder address for Bachmann dcc equipped locos

Started by Sid North, November 22, 2011, 02:22:31 PM

Previous topic - Next topic

Sid North

 ??? I have a bachmann gp30 Reading Lines.  I have tried running it on address code 03 and have had no luck.  I use digitrax control.  I put this unit on my program track and it reads d n d.  What must I do to get control of this unit?

Jim Banner

Assuming your locomotive has a decoder that was factory installed, try the cab number of the locomotive.  Decoders are shipped set to address 03 unless they are installed in a locomotive.  Then they are often set to the locomotive cab number.

From the DND reading, I assume you are using a Zephyr, either the DCS50 or the DCS51.  This command station has troubles reading back certain Lenz type decoders unless you connect a 1000 ohm resistor across the rails of your programming track.  This again assumes a factory installed decoder.

Jim
Growing older is mandatory but growing up is optional.