News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

EZ Command/Dynamis power supply

Started by jake_iv, December 14, 2010, 05:24:26 PM

Previous topic - Next topic

jake_iv

I have a Starr-Tech "Hogger" with 5 amps output at 20 volts  --- Can I replace the 1 amp supply that comes with the basic Bachmann systems with the Starr-Tec Hogger filtered DC?

Jim Banner

The E-Z Command is designed to work with a 1 amp ac power input.  Using dc may overload the built in rectifiers by causing two of them to take the full load while the other two do none of the work.  There is also the question of how the E-Z Command limits over current and over heating.  The wall wart power supply that comes with it reduces its output voltage as more load is put of the command station, helping limit the heat it produces.  Your much higher rated Hogger would not do this and if your E-Z Command were to shut down on thermal overload, it would do so at a lower current than normal because of the higher voltage.  Remember heat = watts = volt x amps.  The higher the voltage, the lower the current to produce the same heat.

If you are looking for more current at the rails to drive more trains, consider adding a booster.  Some boosters come with no built in power supply and your Hogger might be just the thing to power them.

Jim
Growing older is mandatory but growing up is optional.