News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

programming EZ command turnouts with Digitrax

Started by drgwrr476, February 20, 2010, 07:18:32 PM

Previous topic - Next topic

drgwrr476

Hi Folks,

I have two Bachmann EZ Command DCC Equipped turnouts, with a Digitrax Super Empire Builder operating system. I cannot get the turnouts to program. I have followed the instructions for both Bachmann and Digitrax.

Suggestions?

Yours in Model Railroading,

John
Littleton, CO

Yours in Model Railroading,

John
Littleton, CO

the Bach-man

Dear John,
Come visit us at the World's Greatest Hobby on Tour in Denver tomorrow. Digitraxx is here as well as Bachmann. I'm sure that your question can be answered by their techs.
Hope to see you tomorrow!
the Bach-man

drgwrr476

Hi Bach-man,

Could not make the show. So, my question still stands.

Yours in Model Railroading,

John
Littleton, CO

the Bach-man

Dear John,
So does my suggestion: contact Digitrax. They'll be able to help.
Sorry you couldn't get to Denver; it was a great show!
Have fun!
the Bach-man

ABC

You can see if your question is answered here: http://tsd.digitrax.com/-Digitrax Tech Support Depot Link
Or contact Digitrax by by email at: [email protected]

drgwrr476

Folks,

I have contacted Digitrax Tech Support three times now. I have followed the Digitrax instructions on programming turnouts, but my Bachmanns will not program.

John
Yours in Model Railroading,

John
Littleton, CO

ABC

Well, I'm sorry, but a lot of us on the Bachmann forum are not familiar with the workings of the digitrax system, so your last resort is a friend or someone else in the area that has a digitrax DCC system.