Bachmann auto reverse loop module

[oilcan1951]

I model G scale. I just purchased a brand new Bachmann auto reverse loop module and I have what would be considered an Acroos type loop, and my switch does not seem work right.
Sometimes it will allow the engine to go a few feet and then it starts running back and forth on it own. I followed the directions went on youtube and it appears that I installed it properly but I dont know why its doing this. Can anybody help please. THX

[bapguy]

Are you running DCC? The reverser is for DCC only. If DCC did you gap both rails coming off both sides of the turnout?    Joe

[Flare]

I wonder if perhaps the power limit is being exceeded and the system is partially resetting?

This might be prevented using a Booster:  http://shop.bachmanntrains.com/index.php?main_page=product_info&cPath=264_274&products_id=1823

[oilcan1951]

Thanks guys for replying.
I did find out that this is for DCC.
I use analog on my G scale and was told this is what I needed.
Guess I got an extra $50 part I don't need.

[Flare]

Thanks guys for replying.
I did find out that this is for DCC.
I use analog on my G scale and was told this is what I needed.
Guess I got an extra $50 part I don't need.

Don't lose all hope, LGB makes an analog reverse loop module.