How do I program my Bachmann DCC turnouts using JMRI/DecoderPro

Started by rpray, December 02, 2014, 04:50:31 PM

Previous topic - Next topic

rpray

I'm using Bachmann EZ track and all of my turnouts and crossovers are DCC.  I am running this with Digitrax DS51, but I would also like to start using JMRI PanelPro to control the turnouts.  I have ordered a USB interface to connect to the system with JMRI. 

I can program my Bachmann DCC turnouts with my Digitrax DS51 to assign addresses to them.  I would like to figure out how to do this through DecoderPro.  Is this possible?  If so, how do I do it?


rogertra

Quote from: rpray on December 02, 2014, 04:50:31 PM
I can program my Bachmann DCC turnouts with my Digitrax DS51 to assign addresses to them.  I would like to figure out how to do this through DecoderPro.  Is this possible?  If so, how do I do it?



I believe the short answer is "Yes" but as I do not use, at the moment, powered switches I'm afraid I cannot help.

However, if you subscribe to the Yahoo Group [email protected] you'll find lots of helpful people.

Cheers

Roger T.