DCC turnouts: setting up the address using NCE Power Pro

[dudu_georgescu]

The manual is silent on how to setup the addresses of the turnout decoder.

The manual tells me though how to control the turnout. But not how to setup the address of the turnout's decoder ...

Help please ...

[ChrisS]

Who's turnout decoder? I use nce snap it accessory decides and you must install the jumper on the board to program.

[dudu_georgescu]

I have no clue what you just said ... I am using Bachmann DCC turnouts. I am guessing Bachmann DCC decoders (they came preinstalled in the turnouts).  I am a beginner,mind explaining me in layman terms what is the procedure?

Thanks ...

[Jerrys HO]

dudu-

I don't use NCE yet,but this is what I have found. Hope it helps. I have programmed them to my basic controller  and seems similar. Note the programming button in the middle of the ties while holding it down the points will switch a couple of times as the way the loco's do when programming.

http://groups.yahoo.com/group/Bachmann_DCC/message/453

Jerry