I am operating a ez command system dcc with a 5amp booster.After running it for a while, I shut it  down.
The next day I turned it on but I have no power to the tracks. I checked for shorts on track,none.I checked power to command transformer,it comes in,but not out to the track.
However this system is connected to the 5amp booster.I checked that and I have power going in but again no power to the track
What am I missing??

Pete

I have a GP-30 with dcc and sound with a strobe light and would like to find a wiring diagram as my front light and strobe won't light. the bulb is ok.

I have to replace my BAC#44605 transformer. Is there a replacement for this?

Thank you all for your info. I will proceed to figure it out. i purchased the Bachmann wireless system dynamis.

NO it is still in bachmanns web site

Does the bachmann ez command wireless system #36505 allow you to change cv functions and have f28 functions?

I would like to replace my ez command setup with a better system.I'm looking for something inexpensive and EASY to use.I have a 5amp power booster(Bachmann) I still want to use. I also want to still plug in my dc controller into the new system so I can still run dc loco's

I have a HO Acela with dcc on board and would like to add sound.
What would be the best and easiest speaker to use and where would be the best place to install it

I will check the engine for wiring faults. As for the turnouts,they are all the same.The problem happens in forward or reverse at that turnout. this is all Bachmann e-z track.

Track has been cleaned.I replaced the switch. All other sound engines have no problem.

I have a Berkshire 2-8-4 with dcc and sound. It came dcc equipped .I installed sound. It runs and works fine except when it crosses a particular switch.It has no trouble with the other switches. All other engines,whether dc or dcc cross it fine with no stop and go. I have to believe its something in the berkshire engine. I'm looking for ideas.

I have a doodlebug DC with a cracked gear in the power truck.Since Bachmann is sold out on these,does anybody know what is a substitute truck or gears that may be used?

THANX

I have a bachmann DC doodlebug that the motor has died.I would like to replace it I believe it's a single can motor.what motor do I need to replace it?

I didn't say I want to run two. I was just curious.